Please use this identifier to cite or link to this item:
|Title:||Impedance and resistance of carbon ink during cure|
|Keywords:||Impedance;Curing;Resistance;Printed electronics;Carbon paste|
|Citation:||Circuit World, 42 (3): pp. 117 - 126, (2016)|
|Abstract:||The resistivity of cured conductive ink films are dependent on a wide range of process parameters. An early indication of the resistivity that is likely to result following curing can enable these parameters to be optimised and, therefore, improve product quality. This paper aims to report on the use of alternating current (AC) impedance measurement techniques on curing printed ink films as a means of assessing the resistivity likely to be attained following the curing process. Design/methodology/approach - Impedance measurements (100 Hz-10 MHz) were performed on curing conductive carbon ink films printed on polyethylene terephthalate substrates during convective heat curing. A jig was designed to incorporate the test structure in an convection oven such that the effect of cure on the structure impedance could be investigated. Findings - The initial impedance was found to decrease with an increase in the measurement frequency. As the ink films were cured, the impedance magnitude across the 100 Hz-10 MHz range converged with the direct current (DC) resistance value. For a given ink, the ratio of initial AC impedance at 10 MHz to final cured resistance was found to be consistent, thus giving a method where final conductivity can be estimated before cure. Originality/value - Data from printed ink resistance measurements are required to ensure the optimal conductivity of printed devices. However, after the printed structures are fabricated and cured, it is too late to optimise process parameters, leading to significant wastage. AC impedance measurement can give an indication of the final cured resistivity whilst the structure is freshly printed and still in its curing phase, enabling the printing process parameters to be adjusted to improve the resistivity of subsequently printed devices. Measuring AC impedance of printed ink structures in a production environment can, therefore, improve output.|
|Appears in Collections:||Dept of Design Research Papers|
Items in BURA are protected by copyright, with all rights reserved, unless otherwise indicated.