Please use this identifier to cite or link to this item: http://bura.brunel.ac.uk/handle/2438/6860
Full metadata record
DC FieldValueLanguage
dc.contributor.advisorKhan, A-
dc.contributor.advisorEdgecock, R-
dc.contributor.authorFenning, Richard-
dc.date.accessioned2012-10-05T13:09:29Z-
dc.date.available2012-10-05T13:09:29Z-
dc.date.issued2012-
dc.identifier.urihttp://bura.brunel.ac.uk/handle/2438/6860-
dc.descriptionThis thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.en_US
dc.description.abstractThis thesis describes the design of novel magnetic lattices for the transport line and gantry of a charged particle therapy complex. The designs use non-scaling Fixed Field Alternating Gradient (ns-FFAG) magnets and were made as part of the PAMELA project. The main contributions in this thesis are the near-perfect FFAG dispersion suppression design process and the designs of the transport line and the gantry lattices. The primary challenge when designing an FFAG gantry is that particles with different momenta take up different lateral positions within the magnets. This is called dispersion and causes problems at three points: the entrance to the gantry, which must be rotated without distortion of the beam; at the end of the gantry where reduced dispersion is required for entry to the scanning system; and a third of the way through the gantry, where a switch in curvature of the magnets is required. Due to their non-linear fields, dispersion suppression in conventional FFAGs is never perfect. However, as this thesis shows, a solution can be found through manipulation of the field components, meaning near-perfect dispersion suppression can be achieved using ns-FFAG magnets (although at a cost of irregular optics). The design process for an FFAG dispersion suppressor shown in this thesis is a novel solution to a previously unsolved problem. Other challenges in the gantry lattice design, such as height and the control of the optics, are tackled and a final gantry design presented and discussed. The starting point for the transport line is a straight FFAG lattice design. This is optimised and matched to a 45o bend. Fixed field solutions to the problem of extracting to the treatment room are discussed, but a time variable field solution is decided on for practical and patient safety reasons. A matching scheme into the gantry room is then designed and presented.en_US
dc.language.isoenen_US
dc.publisherBrunel University School of Engineering and Design PhD Theses-
dc.relation.urihttp://bura.brunel.ac.uk/bitstream/2438/6860/1/FulltextThesis.pdf-
dc.subjectProton therapyen_US
dc.subjectAccelerator physicsen_US
dc.subjectLattice designen_US
dc.subjectZgoubien_US
dc.subjectPAMELAen_US
dc.titleNovel FFAG gantry and transport line designs for charged particle therapyen_US
dc.typeThesisen_US
Appears in Collections:Electronic and Computer Engineering
Dept of Electronic and Computer Engineering Theses

Files in This Item:
File Description SizeFormat 
FulltextThesis.pdf9.39 MBAdobe PDFView/Open


Items in BURA are protected by copyright, with all rights reserved, unless otherwise indicated.